MULTICHANNEL STEP UP POWER CONVERTER WITH MAGNETICALLY UNCOUPLED FILTERS

Walid Emar, Khader Mohammad, and Mahdi Washha

References

  1. [1] W. Emar, A. Musbah, and I.M.M. El Emary, Double-phaseconnection of switching converters, European Journal of Sci-entific Research, 16(1), 2007, 139–150.
  2. [2] N. Mohan, Power electronics and drives (MN, USA: Universityof Minnesota, MNPERE, 2003).
  3. [3] S. Chand, Modern power electronics, Jadavpur University,Kolkata (Ram Nagar, New Delhi, India: S. Chand & CompanyLtd., 2004).
  4. [4] C. Chunliu, W. Chenghua, and H. Feng, Research of an in-terleaved boost converter with four interleaved boost convertcells, Asia Pacific Conf. on Postgraduate Research in Micro-electronics & Electronics (PrimeAsia) IEEE, Vishakapatnam,India, Vol. 1, 396–399.
  5. [5] A.K. Rathore, Two loop average current control of boost con-verter, National University of Singapore, https://www.ece.nus.edu.sg/stfpage/akr/controlboost.pdf.17
  6. [6] M. Zivanov, B. Sasic, and M. Lazic, Desing of multiphase boostconverter for hybrid fuel cell/battery power sources, in A.Ng (ed.), Paths to sustainable energy (InTech, 2010), Rijeka,Croatia, ISBN: 978-953-307-401-6, DOI: 10.5772/13113.
  7. [7] R. Sheehan, Emulated current-mode control for step up con-verters using sample-and-hold technique, Power ElectronicsTechnology Exhibition and Conf., PES02, Santa Clara, CA,USA, October 2006.
  8. [8] C. Rech and J.R. Piheiro, Line current harmonics reductionin multipulse connection of asymmetrically loaded rectifiers,IEEE Transactions on Industrial Electronics, 52(3), 2005,640–652.
  9. [9] A.P. Dancy, R. Amirtharajah, and A.P. Chandrakasan, High-efficiency multiple-output conversion for low-voltage systems,IEEE Transactions on VLSI Systems, 8(3), 2000, 252–263.
  10. [10] T.D. Burd, T.A. Pering, A.J. Stratakos, and R.W. Brodersen.A dynamic voltage scaled microprocessor system, IEEE JSSC,35 (11), 2000, 1571–1580.
  11. [11] H. Yao, Modeling and design of a current mode control boostconverter, Ph.D. Dissertation, Colorado State University, Fall2012.
  12. [12] Infineon Technologies AG, Setting the P-I controller parame-ters, KP and KI, Application Note, TLE7242 and TLE8242Munich, Germany, 2009, http://www.infineon.com/.
  13. [13] S. Chattopadhyay and S. Das, A digital current mode controltechnique for DC–DC converters, Proc. APEC’05, Austin, TX,2006, 885–891.
  14. [14] J. Li, Current-mode control: Modeling and its digital appli-cation, Ph.D. Dissertation, Virginia Polytechnic Institute andState University, Blacksburg, Virginia, USA, April 14, 2009.
  15. [15] G.M. Di Blasi, V. Boscaino, P. Livreri F. Marino, andM. Minieri, A novel linear–non-linear digital control forD.C./D.C. converter with fast transient response, APEC, Dal-las TX, USA, 2006.
  16. [16] P. Jain, Dynamic conversion circuit for a step up convertermodule, U.S. Patent Application Serial No. 11/261,660, filedon 31 October 2005.
  17. [17] P. Jain, Digital controller for a step up converter module, U.S.Patent Application Serial No. 11/261,661, filed on 31 October2005.
  18. [18] R.W. Erickson and D. Maksimovic, Fundamentals of powerelectronics, 2nd ed. (Dordrecht, The Netherlands: KluwerAcademic Publishers, 2001).
  19. [19] J. Rosas-Caro and J. Mayo-Maldonado, DC–DC multiplierboost converter with resonant switching, Research Volume,February 2015, Vol. 119, 83–90.
  20. [20] H. Yao, Modeling and design of a current mode control step upconverter, Ph.D. Dissertation, Colorado State University, Fall2012.

Important Links:

Go Back